Crystal radio with impedance matching

Autor/Urheber:

Chetvorno

Shortlink:

https://www.dewiki.de/b/16aed2

Quelle:

Wikimedia Commons

Größe:

677 x 426 Pixel (32649 Bytes)

Beschreibung:

A crystal radio receiver circuit that uses impedance matching to increase the power transferred from the antenna through the receiver to the earphone E1. This type of circuit was used in higher quality radios around 1920. Maximum power is transferred from one circuit to another when their impedance (resistance) is equal. However, in a crystal receiver, the impedance of the antenna-ground circuit (around 10-200 ohms) is far less than the impedance of the tuned circuit (L1, C1) (thousands of ohms at resonance) and varies depending on the length of the antenna, etc.. Therefore the antenna is connected to a tap across only a portion of the coil's turns, using a multiposition switch, S1. This makes the tuning coil L1 act as an impedance matching autotransformer in addition to its tuning function, transforming the high impedance of the tuned circuit down by the square root of the turns ratio to match the antenna. The switch S1 is adjusted until the radio station is loudest in the earphone.

The impedance of the crystal detector D1 is also matched to the tuned circuit by connecting the detector, like the antenna, to a tap on the coil. In addition to improving power transfer, impedance matching also improves selectivity of the receiver (its ability to reject interfering signals at nearby frequencies) by reducing the resistive "loading" of the tuned circuit, increasing the Q factor.

The blocking capacitor C2 filters the radio frequency pulses out of the rectified output of the detector. It can often be omitted since the earphone cord usually has sufficient capacitance.

Lizenz:

Public domain

Bild teilen: